Ball screw shaft offset measurement using Dial indicator
Since the ball screw wobbles quite much, some tuning to the bearing blocks was made and after around 30minutes tuning the shaft offset was measured to around 50-60µm (micrometers). This […]
Designing the Y-Axis ballscrew bracket mount plates
A slight re-design is needed from the y-axis endplates. The end plates are to be replaced with mount plates for the BK12 brackets that are on top of the RatRig […]
Say hello to the Aluminum Gantry plates that just arrived!
Al-Men (a local aluminum manufacturer in Finland) provides aluminum in various types like larger aluminum plate sheets from 0.7mm up to 10mm in various sizes. They also provide longer aluminum […]
Recent Comments