HM12 Nema23 Size Motor Mounts Arrived 😁
INTROFinally i got the HM12 motor mounts and I was able to install them on my machine straight away. The Mounts did not fit 1:1 to my old endplate holes […]
CNC Enclosure for laser and overall safety purposes
I still haven’t got the HM12 motor mounts. The are in a neighboring city but for some reason they were sent to west Finland and back to neighbor city (TNT […]
Dust collector cyclone
I have a cheap 60€ dry/wet vacuum but it does not work that good with dust since the dust is collected inside the filter and aftre 15-20minutes the suction power […]
Setting up the new cnc and disassembling old cnc
Setting up AC electric wirings and DC wirings for the CNC is ongoing. I took the on/off switch from the old saw table that was used as table for the […]
Ball screw shaft offset measurement using Dial indicator
Since the ball screw wobbles quite much, some tuning to the bearing blocks was made and after around 30minutes tuning the shaft offset was measured to around 50-60µm (micrometers). This […]
Electronic Wirings from Motor to Power supply
Since the printed motor mounts are too flexible to use with the CNC machine, some steel HM12-57 mounts with C5 bearings was ordered from AliExpress. Mean while, the electronic wirings […]
Bottom frame temporary assembly and installation
In order to be able to finish up the aluminum parts which are slightly different in thickness, the bottom frame needs to be assembled temporary as rigid as possible. The […]
Recent Comments