Vacuum Clamping to the help
So i got an idea of making my sheets of plywood or poly carbonate / Acrylics flat against my working table First i was thinking to invest in a 3D […]
So i got an idea of making my sheets of plywood or poly carbonate / Acrylics flat against my working table First i was thinking to invest in a 3D […]
Opt Lasers provides good quality and range of laser diode driven cnc lasers for engraving and cutting. The lasers are blue lasers working on a wavelength of 445[nm]. They have […]
One week ago i milled the aluminum motor plates for all axises. While Milling one set, the 1 fluted 4mm bit got jammed on an aluminum piece that was not […]
Finally the machine is in a shape that its possible to start making the aluminum plates bought from kauppa.al-men.fi to be replacing the plywood plates. First off the Z axis […]
So I got the profiles from Easy-Systems located in Finland, Lohja. All the parts can be found from the part listing. First of the lowest part of the enclosure needed […]
So here we are. Finally!!! First actual test runs running a GCode to make something with the machine. This has been waited for long. So first off the Z axis […]
INTROFinally i got the HM12 motor mounts and I was able to install them on my machine straight away. The Mounts did not fit 1:1 to my old endplate holes […]
I still haven’t got the HM12 motor mounts. The are in a neighboring city but for some reason they were sent to west Finland and back to neighbor city (TNT […]
I have a cheap 60€ dry/wet vacuum but it does not work that good with dust since the dust is collected inside the filter and aftre 15-20minutes the suction power […]
Setting up AC electric wirings and DC wirings for the CNC is ongoing. I took the on/off switch from the old saw table that was used as table for the […]
Recent Comments